|DGS-025 ¼» (6mm) Mini Die Grinder|
½” Drilling capacity – 22000 Free speed RPM – ¼” Air inlet 4 cfm (115 l/min) average air consumption – 1 ½ hp compressor recommended
|DGR-025 ¼» (6mm) Angle Die Grinder|
½” Drilling capacity – 25000 Free speed RPM – ¼” Air inlet 4 cfm (115 l/min) average air consumption – 1 ½ hp compressor recommended.
|COT-300 3″ Cut Off Tool|
3” (76mm) capacity – 18000 Free speed RPM – ¼” Air inlet 4 cfm (115 l/min) average air consumption – 1 ½ hp compressor recommended.
|ABS-601 Air Body Saw|
Air powered reciprocating saw great for trimming excess materials from cured composite edges. Also handy for cutting our hatches and open areas.
|Rubber Sanding Blocks|
Specifically designed holding sot grips the sandpaper firmly to reduce slipping & tearing. Easy to hold soft sanding block body material stays comfortable in the hand.
Perfect for secondary water removal in small spray guns like our famous G100 Cup Gun caused by air line condensation.
1/4″ Male outlet, 1/4″ Female inlet to fit most small spray guns.
Inexpensive enough to mount to all your spray equipment.
0 — 150 PSI Regulator and guage, perfect for small sprayers and tools where air pressure
readings at the tool is critical.
Plated assembly with knurled knob for instant tool pressure adjustment.
Large, 1″ guage face with PSI and Bar readings.
Economical solution to harsh environments where expensive regulators make little sense.
|End Line Oiler|
Automatically lubricates air tools during use.
Oil reservoir is made of high impact plastic.
Overall Length: 2” (50mm).
Always visible oil supply and oiling action.
Air Inlet: ¼” NPT
Air Outlet: ¼” NPT